[osg-users] Cmake question

J.P. Delport jpdelport at csir.co.za
Thu Jul 31 23:31:41 PDT 2008


you can also pass a param to cmake. This is what "configure" in the osg 
dir does.

OpenSceneGraph$ cat ./configure
cmake . -DCMAKE_BUILD_TYPE=Release


Alberto Luaces wrote:
> Hi Brad,
> on the ccmake setup, press 't' for advanced mode and then search for 
> CMAKE_BUILD_TYPE. The info says that you can select these modes: Debug 
> Release RelWithDebInfo MinSizeRel.
> Alberto
> El Jueves 31 Julio 2008ES 08:29:31 Christiansen, Brad escribió:
>> Hi,
>> Sorry to ask a question that I am sure is covered somewhere, but I just
>> cant find mention of it.
>> How do you select between doing a release and debug build using cmake on
>> linux?
>> I cant find any make targets or cmake options in the setup. It is not
>> mentioned on the wiki and I cant find anything in the mail archives.
>> Cheers,
>> Brad
> _______________________________________________
> osg-users mailing list
> osg-users at lists.openscenegraph.org
> http://lists.openscenegraph.org/listinfo.cgi/osg-users-openscenegraph.org

This message is subject to the CSIR's copyright terms and conditions, e-mail legal notice, and implemented Open Document Format (ODF) standard. 
The full disclaimer details can be found at http://www.csir.co.za/disclaimer.html.

This message has been scanned for viruses and dangerous content by MailScanner, 
and is believed to be clean.  MailScanner thanks Transtec Computers for their support.

More information about the osg-users mailing list