[osg-users] Line disappearing

J.P. Delport jpdelport at csir.co.za
Thu Sep 6 00:55:05 PDT 2007


Hi,

I had a similar problem some time ago, a quad strip would disappear if 
the initial point was outside the camera FOV.

Try ->dirtyBound() on the geometry node you add data to.

jp

bhendrick at knology.net wrote:
> 
> 
>  I have set up a earth globe view where I have a trajectory line that "trails" out of the end of a 3d aircraft model.
> I have two slightly modified versions of a nodeTracker and Terrain manipulator that I am using. (Both have
> slightly modified up vector calculations). My problem is that depending on my viewing angle the trajectory
> line  will disappear. I have set the culling mode on the viewer's camera to NO_CULLING and have tried to 
> set all nodes to setCullingActive(false). The line itself is a primitive class that I append points to as they
> arrive (I get my data elsewhere).The model is placed at the same location as the last point appended 
> to the line.  The behavior seems as follows. If I view the model (which is the node
> currently attached to my nodeTracker) from ANYWHERE  behind the model which is the side the trajectory
> line emminates from (back to the original point), the line disappears. The model never disappears but the entire
> line disappears. It is not clipping the line off at a near clip plane because the entire line disappears, and I am far enough
> away (and off to the side) that at least some if not all the line should be in view.
> _______________________________________________
> osg-users mailing list
> osg-users at lists.openscenegraph.org
> http://lists.openscenegraph.org/listinfo.cgi/osg-users-openscenegraph.org
> 

-- 
This message is subject to the CSIR's copyright terms and conditions, e-mail legal notice, and implemented Open Document Format (ODF) standard. 
The full disclaimer details can be found at http://www.csir.co.za/disclaimer.html.

This message has been scanned for viruses and dangerous content by MailScanner, 
and is believed to be clean.  MailScanner thanks Transtec Computers for their support.




More information about the osg-users mailing list